Lanier LASER 200 Manuel d'utilisateur télécharger pdf (Page 8)

LAN IER – 1/3

Scale Laser 200 ARF -INSTRU CTIONS

46. Install the tail w heel on the axle, then secure

with the sm all w heel collar and set screw . Use

som e thread lock on the screw .

47. L ocate the hard points in the tail surfaces for the

tail brace wires. Pierce the covering with a sh arp

blade. Put a slight bend in (12) of the tail wire

brackets, then install them in the horizontal and

vertical stabilizers as show n, with a bracket on

both sides of the surfaces. Use a 4-40 screw and

lock nut on each bracket.

48. Install a 2-56 clevis on the ends of the (8) 2-56

threaded rods, then install (4) rods in the middle

hole of the vertical braces.

49. M ark the length of the rods about ¼” past the

largest hole in the horizontal braces, then trim.

B end at 90 degrees, then insert in the hole.

Secure with an L connector. Adjust at the clevis

end, but don’t warp the horizontal su rface.

50. Install the tail brace bracket using the rear #6

screw . A ssem ble the other (4) tail brace wires

the sam e as the top, then secure with the L

connectors.

51. M ake su re each clevis gets a keeper installed.

52. L ocate the (4) 4 x 20mm screw s for installation

of the cow l. (2) are round head screw s, (2) are

flat head screw s.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Lanier LASER 200 Manuel d'utilisateur Page 8