Lanier LASER 200 Manuel d'utilisateur télécharger pdf (Page 3)

LAN IER – 1/3

Scale Laser 200 ARF -INSTRU CTIONS

rad io. Center the servo by hooking it up to the

proper channel of your radio and centering the

trim tabs.

9. Install your servo horn so that it is protruding the

hole of the plate and install the servo horn screw .

10. U se a piece of music wire or w ooden dow el to

help feed the servo wires through the wing. Y ou

will need to add extensions to the aileron servo

wires to reach into the fuselage.

11. Fasten the servo plate to the hardw ood plate rails

in the wing with (4) #4 x ½” screw s (dubro

#382)

12. L ocate the Sullivan aileron hardw are, (2)2 7/8” long

4-40 rods, (4) clevis, (2) couplers, (2) m achined

nuts, and (2) 8-32 long” screw s. T rim and thread

the rods as needed. Install a clevis on the end of

each rod.

13. Install a (4) arm servo w heel on the servo

tem porarily, making sure it is parallel to the

wing. L ocate the hard points in the ailerons, and

pierce the covering with a sh arp hobby blade.

Install the (2) aileron control horn screw s from

the top of the wing, dow n through the aileron.

Secure the bolt with the m achined nut, and

thread lock. Install the (2) couplers on the

contro l horn bolts until the threads just show

from the tops. H ook the links to the aileron

couplers and lay the rods across the servo arm .

14. Install the two clevis on the ends of the 4-40 rod.

Align the aileron on the wing and hold in

position with a sm all piece of tape. Adjust the

clevis to the proper length, then install on the

serv o and coupler. Use red thread lock when

adjusted, then install the clevis keeper.

1 2 3 4 5 6 7 8 ... 15 16

Pas de commentaire

Lanier LASER 200 Manuel d'utilisateur Page 3