Lanier LASER 200 Manuel d'utilisateur télécharger pdf (Page 2)

LAN IER – 1/3

Scale Laser 200 ARF -INSTRU CTIONS

BUILDING INSTRUCTIONS

Beforestarting to build this kit, we urge you to read

through these instructions thoroughly. They contain

som e im portant building sequences as w ell as

instructions and warnings concerning the assem bly

and use of the m odel.

BUILDING SU PPLIES NEEDED

H obby knife w/ #11 blade

Medium Zap CA

30 Minute Z-poxy

Wire cutters

Pliers

Drill with bits: 1/32”, 1/16”, 1/8”, 5/32”, ¼”

See the list at the end of the instru ction book for a

list of additional R/C equipm ent you w ill need to

com p lete the 1/3

L aser.

L ocate (10) hinge points.

2. U se the picture as a guide to find the (5) holes in

each aileron and each side of the wing. Test fit a

hinge in each hole.

3. P ut a sm all drop of oil on each hinge, then use 30

minute epoxy on each hinge and hole. Press the

ailerons in place, leaving a 1/32” gap at the hinge

line, then wipe off any excess epoxy off with

alcohol and a paper tow el.

4. A t the two locations on the wing, rem ove the

covering from the hole to install your aileron

servo.

5. M ark the location of the aileron servo plate rails

on the inside of the plyw ood servo plate (aprox.

3/8”). R em ove the covering from the hole for

the serv o arm.

6. P osition your aileron servos and the hardw ood

blocks on the plates and mark the position.

7. G lue the blocks in place on the plates with 30

minute epoxy.

8. W hen cured, replace the servo and drill 1/32”

pilot holes for the servo screw s included with the

1 2 3 4 5 6 7 ... 15 16

Pas de commentaire

Lanier LASER 200 Manuel d'utilisateur Page 2